12-02-2013, 02:47 PM
(11-04-2013, 01:31 PM)youtakun Wrote: Look, mine is even smaller: 1x2x3 long.
Seriously though, what you made isn't a T-FF, it's a T latch, otherwise known as a ticker with hold input. You still need an edge detector to drive it with any signal that isn't already a pulse. A suitable edge detector is also at least 1x2x4.
It's nice to have a short 1-wide silent T-latch though, there are none on the wiki. The only small 1-wide T-FF there is 8 long and uses 2 pistons (and the 0.5tick glitch). The smallest silent 1-wide there is humongous by current standards (T FlipFlop D).
Fixed it with a falling-edge-detector, so you can easily stack them to make a binary ripple counter. Incidentally, it also uses two hoppers.
You mean the one made from 3 droppers (theres something made from 2, but thats unstable) 1 hopper? I seen that in many places.You were the first to invent it?I have machines showed up on youtube 1 or 2 months after i build it.