That might work, and would be a much better implementation for serial (though it would be stuck at 2 ticks minimum). Then, the three values could be 00, 11, and 01/10 (the pulsing one)
That is a good idea as well - 0 would be strength 0-4, 1 would be 5-9, 2 would be 10-15. However, a bus using that implementation would have a very significant delay, unless one were to convert the signal to another representation that doesn't use signal strength.
(10-10-2013, 04:04 AM)Chibill Wrote: How about a three state signal strength systemS
That is a good idea as well - 0 would be strength 0-4, 1 would be 5-9, 2 would be 10-15. However, a bus using that implementation would have a very significant delay, unless one were to convert the signal to another representation that doesn't use signal strength.
I'M BAAAAAAACK!