01-25-2015, 02:49 PM
(This post was last modified: 01-25-2015, 03:57 PM by Apocryphan.)
borrowed an alternate to torches or pistons from my hard drive, so here is a solid state version so i don't need yours =P except yours looks a little shorter maybe, I'll probably make one off those plans too sometime
![[Image: 2ACo0dt.png]](http://i.imgur.com/2ACo0dt.png)
You can carry the signals over and under and use this as an input/output selector
![[Image: 60e8zZo.png]](http://i.imgur.com/60e8zZo.png)
Or make this into a 16 byte rom card with 2 hex outputs per input
![[Image: ST2Ep6x.png]](http://i.imgur.com/ST2Ep6x.png)
I will probably replace my hopper/dropper versions of this selector on my Hard drive, it'd reduce 2-3 ticks and i wouldn't have to lengthen the signal a tick in that decoder
And in case you haven't realized what i'm all about. Hex, Signal Manipulation, Compact, Comparator, seamless stackables and tilables are what i go for in almost every build, and solid state and torchless are a goal too from time to time.
![[Image: bfKDrdH.png]](http://i.imgur.com/bfKDrdH.png)
My only regret is that it doesn't need any more comparators.. yet.
You can carry the signals over and under and use this as an input/output selector
Or make this into a 16 byte rom card with 2 hex outputs per input
I will probably replace my hopper/dropper versions of this selector on my Hard drive, it'd reduce 2-3 ticks and i wouldn't have to lengthen the signal a tick in that decoder
And in case you haven't realized what i'm all about. Hex, Signal Manipulation, Compact, Comparator, seamless stackables and tilables are what i go for in almost every build, and solid state and torchless are a goal too from time to time.
My only regret is that it doesn't need any more comparators.. yet.