12-01-2014, 08:26 AM
(This post was last modified: 12-01-2014, 08:46 AM by Apocryphan.)
Hi TacoMan!
Ok, so i decided to make each 4hx16w modular by moving the AND gate triggers to the center, each 4hx16w only needs 4 data sets of 5 hex, so if you include the 2 tick gap between signals, it should only take 48 ticks to load the whole gui with a picture, no matter the size, as long as each 4x16 has it's own wire, i'm not sure if you'd consider it parallel since the wires don't send a fraction of each data set, but it does send a fraction of the overall picture on each wire.
![[Image: 84Tawhp.png]](http://i.imgur.com/84Tawhp.png)
![[Image: 3BoAXAQ.png]](http://i.imgur.com/3BoAXAQ.png)
Full Album:
http://imgur.com/a/4vROM
Ok, so i decided to make each 4hx16w modular by moving the AND gate triggers to the center, each 4hx16w only needs 4 data sets of 5 hex, so if you include the 2 tick gap between signals, it should only take 48 ticks to load the whole gui with a picture, no matter the size, as long as each 4x16 has it's own wire, i'm not sure if you'd consider it parallel since the wires don't send a fraction of each data set, but it does send a fraction of the overall picture on each wire.
Full Album:
http://imgur.com/a/4vROM